When you do this you should see 'SAVED SETUP OK' message after the Player 1 START button is pushed. If the cabinet TEST Switch is not installed or unavailable, set DIP SW 3 – BIT 4 on the XX-in-1 PCB to the ON position (This is the blue set of switches located on the PCB), then power up the board.Īfter any changes are made on the setup/settings page(s), press the PLAYER 1 START Button prior to leaving that page and going on to the next (or shutting off the board). Once the board begins to boot up in the TEST mode then release the TEST switch. To access the TEST/Setup Mode, press and hold the cabinet TEST Switch in the ON position and then power on the board. How to access the TEST/Setup Menu on the XX-in-1 Multigame PCBĪrticle Number: 20 | Rating: Unrated | Last Updated: Mon, at 6:23 AM Jamma is a term used to describe a INTERFACE. ![]() ![]() I have stated this before,but i guess reading is not a first thing ?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |